Assembly requirements

Before Side Dumping Mining Wagons general assembly, all parts (including purchased parts and standard parts) must be inspected before they can be used.

All parts should be cleaned and carried out in a clean environment.

The traction height of the mine car is ±3mm, the total width is ±5mm, the total height is ±8mm, and the total length is ±10mm

The car box should be installed symmetrically on the longitudinal center plane of the frame, and its symmetry tolerance is 5mm.

The assembled mine cart should be placed on a special straight track for inspection, and the gap between a wheel and the rail surface is not allowed to be greater than 2mm.

The mine car runs smoothly whether in a bend or a straight.

All parts are painted with phenolic primer, and the body is painted according to the contract requirements. The appearance of the paint is required to be uniform, flat, consistent in color tone, complete coverage, and no defects such as brush marks, peeling, accumulation and blistering. Check the adhesion of the paint film by cross-cutting. The coating does not fall off or partly falls off at the edge of the grid or at the intersection of the cut, and the fall off area is not more than 15%.