Installation and debugging

Before installing the Side Dumping Mining Wagons, first check the installation position of the mine car, check the track laying condition, whether the parallelism and flatness of the two rails meet the requirements, and adjust if necessary. The top of a straight track shall be at the same level, and the allowable error in the length direction shall not exceed 1mm per meter or 3mm per 10m.

The allowable error at the corresponding measuring point in the left and right directions is not more than 2mm.

After carefully checking that there is no problem, according to the installation requirements, ensure that the centerline of the wheel set of the minecart coincides with the centerline of the track.

During trial operation, observe whether the mine wheel pair is rubbing against the track, and deal with it in time to prevent damage to the mine car.During the trial operation, observe whether the car body is tilted, out of the track or overturned after it collides with another car while sliding along the slope curve. During the trial operation, observe whether the minecart is traveling through the track with the smallest radius of curvature, whether there is any collision, interference, or track gnawing.